30L FermZilla All Rounder Easy-Grip Pressure Fermenter Starter Kit

Get the highest grossing selling PET Pressure fermenter in the world!
Complete with Red Gas & Yellow Liquid Carbonation Caps, weighted mesh dip tube filter with float. Ensuring that you’re getting the clearest possible liquid from your fermenter down to the last drop.
Includes the new and improved Easy-Grip Threaded Lid Ring for ease of tightening and undoing.
Reinforced Hex Base now as standard. No more fiddling around with straps and tie downs.
And of course, comes complete with the infamous Red BlowTie spunding valve to allow you to ferment under pressure safely in your new FermZilla.

This brewing kit has been put together by those who want all the benefits of an affordable pressurisable fermentation/transfer vessel, but don’t want the extended cleaning times that one would normally do with a Conical FermZilla. That isn’t to say that this is better than the others, it is simply the best All Round solution for one with a busy life schedule who also wants to brew the absolute best that they can.

This is the ideal starting point for any new brewer looking to get into pressure fermenting; or simply someone who wants to transfer out of the vessel using pressure to lessen oxygen pick up in their final beverage. The perfect scenario is always going into a stainless steel 19L or 9.5L kegs with Low2 O-Rings post fermentation.

Kegland Australia has a great breakdown about the benefits of pressure fermentation here, and a guide to closed transfer here.

We would also still recommend getting a CO2 Gas to be able to transfer to a keg/bottle/can or dispense directly out of the unit. As these units were designed to be fermenting and pressure transfer vessels for your delicious cargo.

What does the fermenter kit come with?

The 30L Fermzilla fermenter with easy grip lid, hex base, red and yellow carbonation caps (gas in, liquid out), red pressure relief valve, weighted stainless float with diptube and mesh filter and… 1 x KB03529  – Integrated Gauge BlowTie Kit (0-15psi) (Spunding valve) – Everything in the photos, everything you need  to get pressure fermenting!

If you want to use the unit as a non-pressure vessel you’ll need to get an airlock and cap/bung for it.

*The above items cannot be removed / altered within this kit*

Warnings:
Please read the instructions thoroughly before use. The current version can be found in the ‘instructions‘ tab above. We will not be held liable for misuse or mishandling of the unit contrary to the instructions.
Keeping the units out of direct sunlight is a must for all PET fermenters. Sunlight degrades PET.

Please note:
When using this vessel under pressure. You must perform a water pressure check to ensure your connections are leak proof. To do this. Fill your FermZilla up with water, then apply a minimum of 15psi pressure to the vessel. Check for leaks around all Cap / Threads.

Occasionally these units may come with some small indentations/dimples/dents from shipping, this is just a reality of shipping large blow-moulded thin-walled vessels. But dont panic, these fermenters are designed to endure minor deformations such as this. This was a necessary implementation into the design so that they can withstand some accidental suction from cold crashing and rough handling in transit without compromising their integrity and ability to endure high pressures. All small dents will push out and settle with use and positive pressure and are only an issue and warrant replacement in the rare event they start to show white stress patterns or have damaged the plastic.