4 Tap T-Bar Flooded Font – Stainless Steel (Glycol)

Give your bar the classic iced-up look with this 4-tap T-Bar flooded font in stainless steel. Glycol runs through the font, chilling the beer lines right up to the taps and frosting the outside. It comes with the internal hosing already fitted, so setup is quick. It’s a great fit for bars, pubs, cafés and event stalls.

Running glycol instead of water lets the font get cold enough to ice up on the outside without freezing the beer inside. How cold you can run it depends on the strength of what you’re pouring: light beers may freeze. It isn’t recommended for soda water lines if you’re running it cold enough to ice up.

It’s designed for use with the IceMaster G40.1 or G80 glycol chiller. The G40.1 is ideal if your kegs are kept cold, or if the beer is chilled enough in a single pass through the chiller. In warmer climates, KegLand recommends the G80 with the beer lines double-looped.

Specifications

• Taps: 4
• Height: 430mm from base flange to top (fitted)
• Width: 400mm
• Benchtop hole: 70mm. Suits benchtops up to 90mm thick
• Mounting: twist-lock anchor with three tension bolts
• Glycol connections: 2 x 10mm barbs (the lower one is the inlet)
• Beer lines: 4 x EVABarrier 4mm ID x 8mm OD, pre-fitted, with about 50mm past the base for your fittings
• Material: 304 stainless steel with a durable clear gloss finish

What else you’ll need

This is the font only. For each of the 4 taps you’ll also need:

• K-Lok female x 3/4″ male fitting (KL04947)
• NukaTap stainless steel tap (KL15509)
• K-Lok tap shank adaptor (KL04954)
• A tap handle of your choice

Drip tray: pair it with the medium plinth drip tray (410mm x 480mm), sold separately. The drip tray isn’t pre-drilled for the font, so you’re free to choose your own taps and layout.

Please note: although the hosing is pre-fitted, always leak test before use.