DIY Tap Handle Inserts – Dual Threaded – 3/8″-16 threads, .625″ Length

DIY Beer Tap Handle Inserts – Dual Threaded – 3/8″-16 threads, .625″ Length

Want to make your own unique tap handles? But the thread type is strange and overseas prices are just $$$! KegLand now has the answer with these simplistic brass inserts.
All you’ll need is a 12.7mm (1/2″) Hole drilled into your handle (Pine, Red Gum, Oak, Cherry, Maple ect) Then screw in with a large flat screw driver.

It is important not to push down too hard if you’re going to using a screw driver, or wide drill bit. It will strip the thread. Let the piece cut into the wood. Ensure that it is straight.

Suits NukaTap and Intertap taps